Service Instruction No. 1343 C
Set Screw for Propeller Governor Idler Shaft
Supersedes Service Instruction No. 1343B
March 10, 2016
MODELS AFFECTED
The following Wide Cylinder Flange Engines that are equipped with a front crankcase mounted propeller governor:
- O, IO, LIO, AIO, AEIO-320 Series
- O, LO, IO, LIO, AIO, AEIO, TO, TIO-360 Series
- O, IO, AEIO, TIO, LTIO-540 Series
- IO-580 Series
- IO-720
TIME OF COMPLIANCE
At each installation of propeller governor set screw
REASON FOR REVISION
Added “E” serial number engines; clarified instructions; added figures and torque for set screw
This Service Instruction is notification of a rework procedure to remove a spring pin part number (P/N) MS-9048-111 (if installed on affected Lycoming engine models) and install a 10-32 set screw in the propeller governor idler shaft in place of the spring pin during the next engine overhaul.
Product Support Network
Wherever you are in the world, you have access to exceptional expertise and knowledge about Lycoming engines. Get the most comprehensive customer service and support in the general aviation industry.
Get It Exchanged
Use our Engine Exchange Program to order a new, rebuilt, or overhauled engine to experience more airtime and less downtime.